Hardware configuration

[ochipara]

Hi,

Is it possible to configure the start/end frequency and sweep time under EaKiu?
I'm using a Mac and I would hate to have to run vmware to get data of out wispy.
If there is any other solution that would work on Macs please let me know.

Thanks,
-- Octav

PS: I have a wispy 2.4x

[brian]

The current version of Eakiu does not support changing the sweep configuration.* I'm not sure if that feature is planned for a future version of the software.We are working on a Mac version of Chanalyzer, as well, which we hope to have out sometime in the next couple of months.

[ochipara]

Is there any documentation on what are the serial commands to set these parameters? If there is documentation it should be fairly straight forward to do it.

Also, I was wondering if there is something like an SDK that we may use.

[KaneHau]

Aloha Ochipara:

With version 5.6 of EaKiu, all parameters of the WiSpy devices are fully programmable. Note that this is currently restricted to the 2.4i, DBm, and 900x WiSpy units.

Enjoy!
david